EFD 800 Spezifikationen PDF herunterladen (Seite 16)

www.nordsonefd.com [email protected] Sales and service of Nordson EFD dispensing systems are available worldwide.

16 System Assembly

Step 6: Connect the Tank Reservoir

and Lubricant Filter

Step 5: Connect the Valve Hoses

1. Find a suitable location and mount the two

air manifolds. One manifold is for the white

Control Air

hose and the other is for the

black

Nozzle Air

hose.

2. Connect a suitable length of black 6 mm

tubing between the valve controller

Nozzle Air

outlet fitting and the air mani-

fold inlet which has black push-in fittings.

3. Connect a suitable length of white 6 mm

tubing between the valve controller

Control Air

outlet fitting and the air man-

ifold inlet which has white push-in fittings.

4. Using the black and white 4 mm tubing,

connect each color-coded valve fitting to

the appropriate colored manifold fitting,

cutting the tubing to the appropriate length

as you proceed.

5. Using the clear 4 mm tubing, connect the

appropriate length of tubing to the fluid

manifold at the back of the controller

using the compression nut provided and

connect the opposite end to the appropri-

ate spray valve inlet push-in fitting.

6. Using the spiral wrap supplied, group and

wrap each valve tri-hose to provide a neat

installation and prevent damage due to

loose hoses.

Step 4: Connect the Press Air Solenoid (cont’d.)

1. Select the appropriate 3-way solenoid.

Flow must meet or exceed .06 cu.

m./min. (2.0 cfm) at 4.14 bar (60 psi).

2. Cut the control air hose at a convenient

location and install the solenoid as shown.

3. Connect the solenoid wires to the press

control circuit.

The tank reservoir is supplied with a lubricant

filter, fluid hose, air hose and low level switch

cable.

Connect the tank to the controller as follows:

1. Connect the grey air hose to the

Tank Air

fitting on the back of the controller. Connect

the opposite end of the hose to the

Tank Air

Inlet

fitting on top of the tank.

2. Mount the filter adapter to the tank reservoir

or MicroCoat stand using the hardware

provided.

3. Connect the clear fluid hose to the

Fluid

Inlet

connector on the manifold at the back

of the controller. Then connect the opposite

end of the fluid hose to the outlet fitting at

the bottom of the tank reservoir.

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 27 28

Kommentare zu diesen Handbüchern

Keine Kommentare

EFD 800 Spezifikationen Seite 16

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Wasserspender EFD 800